FixVault
Home › Chevrolet › 2012 › Camaro LS, Automatic Trans › Repair and Diagnosis › Engine Mechanical › Fuel System › Engine Controls/Fuel - 3.6L - Repair Instructions › Repair Instructions › Accelerator Pedal Position Sensor Replacement › Installation Procedure

Installation Procedure

    Fig 1: Locating APP Sensor
    GM1407620Courtesy of GENERAL MOTORS COMPANY
  1. Install the APP sensor to the front of dash.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the APP sensor mounting nuts and tighten to 9 N.m (80 lb in).
  3. Connect the APP sensor electrical connector.
  4. Operate the accelerator pedal and observe the APP angles using a scan tool. The accelerator pedal should operate freely, without binding between closed throttle and wide open throttle.
  5. Install the closeout/insulator panel.
About FixVault