FixVault
Home › Chevrolet › 2012 › Caprice 3.6 3 › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Controls/Fuel - 3.6L - Repair Instructions › Repair Instructions › Manifold Absolute Pressure Sensor Replacement › Installation Procedure

Installation Procedure

    Fig 1: Intake Manifold Assemble
    GM2219477Courtesy of GENERAL MOTORS COMPANY
  1. Install a NEW MAP sensor seal.
  2. Install the MAP sensor (2) to the intake manifold assembly.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the MAP sensor to intake manifold retaining bolt (1) and tighten to 4 N.m (35 lb in).
  4. Connect the engine wiring harness to the manifold absolute pressure (MAP) sensor (2).
About FixVault