FixVault
Home › Chevrolet › 2012 › Caprice 6.0 2 › Repair and Diagnosis › Body & Frame › Door Locks › Theft Deterrent System › Repair Instructions › Theft Deterrent Module Replacement › Installation Procedure

Installation Procedure

    Fig 1: Identifying TDM & Steering Column Assembly
    GM1958114Courtesy of GENERAL MOTORS COMPANY
    IMPORTANT:

    Make sure the locating pin on the steering column assembly (2) is aligned with the TDM (1).

  1. Install the TDM (1) to the steering column assembly (2).
    2. Fig 2: Identifying Theft Deterrent Module (TDM) Electrical Connector
    GM1958113Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Install the TDM to steering column assembly retaining screw (3).

    Tighten 

    Tighten the screw to 1 N.m (9 lb in).

    3. IMPORTANT:

    Rotate the ignition lock cylinder lamp socket counter-clockwise to disengage the locking tangs and pull to detach the ignition lock cylinder lamp socket (2) from the TDM.

  3. Detach the ignition lock cylinder lamp socket (2) from the TDM (1).
  4. Connect the theft deterrent module (TDM) electrical connector (4).
  5. Install the steering column trim covers. Refer to Steering Column Trim Cover Replacement .
  6. Connect the battery ground cable. Refer to Battery Negative Cable Disconnection and Connection (Primary) , Battery Negative Cable Disconnection and Connection (Auxiliary) .
  7. Enable the SIR system. Refer to SIR Disabling and Enabling .
  8. For programming and set up, refer to Control Module References .
About FixVault