Installation Procedure

WARNING: This page is about a different car, the 2011 Chevrolet Caprice. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Side Impact Sensor Securing Bolt

Courtesy of GENERAL MOTORS CORP.

Install the side impact sensor (2) to the centre pillar (3).

CAUTION:

Refer to Fastener Caution .

Install the side impact sensor (2) securing bolt (4) and tighten to 9 N.m (80 lb in)
Connect the side impact sensor electrical connector to the side impact sensor (1).
Install the door sill plate. Refer to Door Sill Plate Replacement .
Install the lower centre pillar trim panel. Refer to Center Pillar Lower Trim Panel Replacement .
Enable the SDM, refer to SIR Disabling and Enabling .
Ignition ON, observe the air bag warning indicator in the instrument panel cluster. The warning indicator should be illuminated for approximately five seconds. During this period the SDM performs a wiring and self-check. If no system faults are detected, the air bag warning indicator will be switched off.
NOTE:
If the warning indicator remains illuminated, a warning is shown in the instrument panel cluster multi-function display and an audible alarm chimes, or the warning indicator illuminates two seconds after it was originally switched off, a fault is present.