Fastener Tightening Specifications
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| A/C Evaporator Tube at TXV Nut | 22 N.m | 16 lb ft |
| Actuator Retaining Screws- All | 1.6 N.m | 14 lb in |
| Actuator Screws- All | 1.6 N.m | 14 lb in |
| Actuator Support Bracket Screws | 1.6 N.m | 14 lb in |
| Actuator Support Bracket Retaining Screws | 1.6 N.m | 14 lb in |
| Air Distribution Duct Bracket Bolt | 10 N.m | 7 lb ft |
| Air Distribution Duct Retaining Screws | 1.6 N.m | 14 lb in |
| Air Distribution Duct Screws | 1.6 N.m | 14 lb in |
| Air Inlet Housing Retaining Screws | 1.6 N.m | 14 lb in |
| Air Inlet Housing Screws | 1.6 N.m | 14 lb in |
| Blower Motor Retaining Screws | 1.6 N.m | 14 lb in |
| Blower Motor Screws | 1.6 N.m | 14 lb in |
| Compressor Clutch Assembly Bolt | 10 N.m | 89 lb in |
| Compressor Drain Plug | 15 N.m | 11 lb ft |
| Compressor High Pressure Relief Valve | 8 N.m | 70 lb in |
| Compressor Hose Assembly to Compressor Bolt | 22 N.m | 16 lb ft |
| Compressor Hose Assembly to Compressor Retaining Nut | 22 N.m | 16 lb ft |
| Compressor Hose Assembly to Condenser Bolt | 22 N.m | 16 lb ft |
| Compressor Hose to Condenser Fitting Bolt | 22 N.m | 16 lb ft |
| Compressor Manifold Stud | 10 N.m | 89 lb in |
| Compressor Mounting Bolts | 50 N.m | 37 lb ft |
| Compressor Mounting Bracket Bolts | 50 N.m | 37 lb ft |
| Defroster Duct Retaining Screws | 10 N.m | 89 lb in |
| Defroster Duct to Upper I/P Beam Bolts | 10 N.m | 89 lb in |
| Defroster Duct to Upper Tie Bar Screws | 5 N.m | 44 lb in |
| Engine Wire Harness Bracket Bolt | 10 N.m | 89 lb in |
| Evaporator Inlet Line to A/C Condenser Bolt | 22 N.m | 16 lb ft |
| Floor Air Outlet Duct Retaining Screws- All | 1.6 N.m | 14 lb in |
| Floor Air Outlet Duct Screws- All | 1.6 N.m | 14 lb in |
| Heater Core Cover Retaining Screws | 1.6 N.m | 14 lb in |
| Heater Core Cover Screws | 1.6 N.m | 14 lb in |
| Heater Pipe Assembly to Heater Core Bolt | 14 N.m | 10 lb ft |
| Heater Pipe Assembly Bracket Bolt | 10 N.m | 7 lb ft |
| Heater Pipe Assembly Retaining Bolt | 14 N.m | 10 lb ft |
| Heater Pipe Bracket Retaining Nut | 10 N.m | 7 lb ft |
| HVAC Module to Bulkhead Nuts | 10 N.m | 89 lb in |
| HVAC Module Case Half Screws | 1.6 N.m | 14 lb in |
| HVAC Module Case Studs | 4 N.m | 35 lb in |
| HVAC Module to Dash Retaining Nuts | 10 N.m | 89 lb in |
| HVAC Module to Upper I/P Beam Bolts | 5 N.m | 44 lb in |
| HVAC Module to Upper I/P Beam Retaining Bolts | 5 N.m | 44 lb in |
| Liquid Line to Condenser Bolt | 22 N.m | 16 lb ft |
| Mode Valve Assembly Retaining Screws | 1.6 N.m | 14 lb in |
| Mode Valve Assembly Screws | 1.6 N.m | 14 lb in |
| Passenger Compartment Air Filter Housing Screws | 1.6 N.m | 14 lb in |
| Refrigerant Pressure Sensor | 5 N.m | 44 lb in |
| Speaker to Air Distribution Duct Screws | 2.5 N.m | 22 lb in |
| TXV to Evaporator Core Bolts | 7 N.m | 62 lb in |
| TXV to Evaporator Core Mounting Bolts | 7 N.m | 62 lb in |
| TXV Block Fitting Bolt | 22 N.m | 16 lb ft |
| Valve Core | 11 N.m | 97 lb in |