FixVault
Home › Chevrolet › 2012 › Corvette Base, 2D Convertible, Automatic Trans › Repair and Diagnosis › Engine Mechanical › Fuel System › Engine Controls/Fuel - Repair Instructions › Repair Instructions › Fuel Tank Pressure Sensor Replacement › Removal Procedure

Removal Procedure

    Fig 1: View Of EVAP Canister Access Cover In Right Rear Wheelhouse
    GM561137Courtesy of GENERAL MOTORS COMPANY
  1. Remove the right rear wheelhouse panel. Refer to Rear Wheelhouse Panel Liner Replacement .
  2. Remove the evaporative emission (EVAP) canister access cover.
  3. Disconnect the fuel tank pressure sensor electrical connector.
  4. Remove the fuel tank pressure sensor by carefully prying the sensor out of the fuel tank with a screwdriver.
About FixVault