FixVault
Home › Chevrolet › 2012 › Cruze LS, Automatic Trans › Repair and Diagnosis › Body & Frame › Ignition Switch/Steering Lock › Wiring Systems And Power Management - Repair Instructions › Repair Instructions › Fuse Block Replacement › Installation Procedure

Installation Procedure

  1. Install fuse block.
    2. CAUTION:

    Refer to Fastener Caution

  2. Install body wiring harness and 2 body wiring harness nuts and tighten to 4.7 N.m (42 lb in).
  3. Install the positive battery cable. Refer to Battery Positive Cable Replacement .
    4. Fig 1: Fuse Box Cover, Battery Cable And Nut
    GM2027594Courtesy of GENERAL MOTORS COMPANY
  4. Install the positive battery cable to starter (3).
  5. Install the positive battery cable to starter nut (2) and tighten to 9 N.m (80 lb in).
    6. Fig 2: Battery Fuse Box Cover
    GM2577153Courtesy of GENERAL MOTORS COMPANY
  6. Close the battery fuse box cover and lock the retaining tabs (1) and (4).
  7. Connect battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
About FixVault