FixVault

Steering Wheel Inflatable Restraint Module Coil Replacement

WARNING: This page is about a different car, the 2011 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Inflatable Restraint Steering Wheel Module Coil And Bolts
GM1998552Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Remove the steering column upper trim cover. Refer to Steering Column Upper Trim Cover Replacement .
  2. Remove the steering column lower trim cover. Refer to Steering Column Lower Trim Cover Replacement .
  3. Remove the steering wheel. Refer to Steering Wheel Replacement .
1 Steering Wheel Inflatable Restraint Module Coil Screw Bolt (Qty: 4)
CAUTION: Refer to Fastener Caution .

Tighten:  1.5 N.m (13 lb in)

2 Steering Wheel Inflatable Restraint Module Coil
Procedure: 
Disconnect any electrical connectors as needed.
Tip: 
  • Do not remove the centering tab from a new steering wheel inflatable restraint module coil until it has been installed or re-centering will be required.
  • If re-centering of the steering wheel inflatable restraint module coil is needed then refer to Inflatable Restraint Steering Wheel Module Coil Centering .