FixVault
Home › Chevrolet › 2012 › Cruze LS, Standard Trans › Repair and Diagnosis › External Pages › Different car › Section 308 (Supplemental Inflatable Restraint System) › Repair Instructions › Airbag Steering Wheel Module Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2014 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying The Electrical Connectors
    GM2103149Courtesy of GENERAL MOTORS COMPANY
  1. Connect the electrical connectors (1).
    2. Fig 2: Steering Wheel SIR Module
    GM2189274Courtesy of GENERAL MOTORS COMPANY
  2. Align the steering wheel module fasteners to the steering column fastener holes.
    3. WARNING:

    After installation of the steering wheel airbag module to the steering wheel, slightly pull the module outward. If there is no give on the airbag module then it is secured correctly. If the airbag module is not fully attached personal injury could result.

  3. Push the steering wheel module (1) firmly into the steering column in order the engage the fasteners.
  4. Install the steering column upper trim cover. Refer to Steering Column Upper Trim Cover Replacement
  5. Enable the SIR system. Refer to SIR Disabling and Enabling .
  6. After replacing the module, fully deploy the old module before disposal.
About FixVault