FixVault
Home › Chevrolet › 2012 › Orlando LS, Automatic Trans › Repair and Diagnosis › Brakes › Traction Control › Antilock Brake System › Repair Instructions › Brake Pressure Modulator Valve Replacement › Installation Procedure

Installation Procedure

    Fig 1: BPMV and BPMV Bracket Bolts
    GM2027916Courtesy of GENERAL MOTORS COMPANY
  1. Install the BPMV insulator (1) to the BPMV bracket (3).
  2. Install the BPMV (2).
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the 3 BMPV bracket bolts (4) and tighten to 10 N.m (89 lb in).
    4. Fig 2: BPMV Bracket Bolts
    GM2501297Courtesy of GENERAL MOTORS COMPANY
  4. Install the BPMV bracket assembly (1).
  5. Install the 2 BPMV bracket bolts (2) and tighten to 20 N.m (15 lb ft).
    6. Fig 3: BPMV Brake Lines
    GM2501292Courtesy of GENERAL MOTORS COMPANY
  6. Install the 6 brake pipes (1, 2) to the BPMV and tighten to 18 N.m (13 lb ft).
  7. Connect the electrical connector to the EBCM/EBTCM.
    8. Fig 4: Brake Fluid Reservoir Cap And Special Tool
    GM2027346Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    When adding fluid to the brake fluid reservoir or to the clutch fluid reservoir, use only DOT-4+ brake fluid from a clean, sealed container. This polyglycol brake fluid is hygroscopic and absorbs moisture. Do not use fluid from an open container that may be contaminated with water. Improper or contaminated fluid could result in damage to the system components.

  8. Remove the CH-558-10  cap (1) and install the brake fluid reservoir cap.
    9. Fig 5: Radiator Surge Tank
    GM2191081Courtesy of GENERAL MOTORS COMPANY
  9. Install the radiator surge tank (1).
  10. Install the radiator surge tank clip (2).
  11. Install battery tray. Refer to Battery Tray Replacement (without Start/Stop System)
    12. CAUTION:

    When adding fluid to the brake fluid reservoir or to the clutch fluid reservoir, use only DOT-4+ brake fluid from a clean, sealed container. This polyglycol brake fluid is hygroscopic and absorbs moisture. Do not use fluid from an open container that may be contaminated with water. Improper or contaminated fluid could result in damage to the system components.

  12. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding .
  13. Program the EBCM. Refer to Electronic Brake Control Module Programming and Setup .
  14. Calibrate the brake pressure modulator valve pressure sensor. Refer to Brake Pressure Modulator Valve Pressure Sensor Calibration .
  15. Center the steering angle sensor. Refer to Steering Angle Sensor Centering .
About FixVault