FixVault
Home › Chevrolet › 2012 › Orlando LS, Automatic Trans › Repair and Diagnosis › Electrical › Charging Systems › Battery, Charging System And Starting System › Repair Instructions › Generator Replacement (2.0L Diesel LNP) › Installation Procedure

Installation Procedure

    Fig 1: Generator Retaining Bolts
    GM2506274Courtesy of GENERAL MOTORS COMPANY
  1. Install the generator (2).
  2. Install the lower generator retaining bolt (3).
  3. Install the upper generator retaining bolt (1).
    4. CAUTION:

    Refer to Fastener Caution.

  4. Tighten the 2 generator retaining bolts (1, 3) to 58 N.m (43 lb ft).
    5. Fig 2: Generator Cap And Positive Cable Retaining Nut
    GM2506273Courtesy of GENERAL MOTORS COMPANY
  5. Install the positive generator cable (4) to the generator.
  6. Install the generator positive cable retaining nut (3) and tighten to 17 N.m (13 lb ft).
  7. Fold the generator cap (2) to the generator positive cable terminal.
  8. Connect the generator wiring harness plug (1) to the generator.
  9. Clip in the engine wiring harness to the knock sensor 2 wiring harness plug bracket.
  10. Install the transmission rear mount:
    • Automatic transmission, refer to Transmission Rear Mount Replacement (Hydraulic Power Steering), Transmission Rear Mount Replacement (Electronic Power Steering).
    • Manual transmission, refer to Transmission Rear Mount Replacement (Hydraulic Power Steering).
  11. Install the drive belt tensioner. Refer to Drive Belt Tensioner Replacement.
  12. Install the front compartment insulator. Refer to Front Compartment Insulator Replacement.
  13. Lower the vehicle.
  14. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (without Start/Stop System) .
About FixVault