FixVault
Home › Chevrolet › 2012 › Orlando LS, Standard Trans › Repair and Diagnosis › Brakes › Traction Control › Antilock Brake System › Diagnostic Information and Procedures › Traction Control/Stability Control Indicator Malfunction › Circuit/System Testing

Circuit/System Testing

NOTE:

Circuit/System Verification must be performed before Circuit/System Testing.

  1. Ignition OFF, disconnect the harness connector at the S75 Traction Control Switch.
  2. Test for less than 5 Ω between the ground circuit terminal 4 and ground.
    • If 5 Ω or greater 

      Repair the open/high resistance in the circuit.

    • If less than 5 Ω 
  3. Ignition ON, verify the scan tool BCM Traction Control Switch parameter is Inactive.
    • If not Inactive 
    1. Ignition OFF, disconnect the X2 harness connector at the K9 Body Control Module.
    2. Test for infinite resistance between the signal circuit terminal 2 at the S75 Traction Control Switch and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance, replace the K9 Body Control Module.
    • If Inactive 
  4. Install a 3 A fused jumper wire between the signal circuit terminal 2 and ground.
  5. Verify the scan tool BCM Traction Control Switch parameter is Active.
    • If not Active 
    1. Ignition OFF, disconnect the X2 harness connector at the K9 Body Control Module.
    2. Ignition ON, test for less than 0.3 V between the signal circuit and ground.
      • If greater than 0.3 V, repair the short to voltage on the circuit.
      • If less than 0.3 V
    3. Ignition OFF, test for less than 2 Ω in the signal circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the K9 Body Control Module.
    • If Active 
  6. Test or replace the S75 Traction Control Switch.
About FixVault