FixVault
Home › Chevrolet › 2012 › Traverse LS, AWD › Repair and Diagnosis › Electrical › Instrument Panel System Displays And Gauges › Diagnostic Information and Procedures › DTC P0461 › Component Testing

Component Testing

  1. Ignition OFF, remove the fuel level sender and verify there are no obstructions interfering with the fuel level sender.
    • If any interference is present, repair the fuel sender interference.
  2. Ignition OFF, disconnect the harness connector at the fuel level sensor.
  3. While sweeping the fuel level sensor through its full range of motion, test for a minimum resistance value of less than 42 Ω and a maximum value greater than 246 Ω between the signal terminal D and the low reference terminal C.
    • If not within the specified range, replace the fuel level sensor.
About FixVault