Installation Procedure
WARNING: This page is about a different car, the 2013 GMC Acadia, 2013 Chevrolet Traverse, and 2013 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
- Install the trailer hitch (1).
- Install the trailer hitch bolts (2-4).
Tighten
Tighten the bolts to 108 N.m (80 lb ft).
- If necessary raise the exhaust system by installing the rubber insulators to the exhaust underbody hangers (1. 2, and 3).
- If previously removed, install the trailer wire harness connector (1) to the trailer hitch (2).
- Connect the body wire harness (2) to the trailer wire harness connector (1).
- lower the vehicle.
CAUTION:
Refer to Fastener Caution .