Removal Procedure
WARNING: This page is about a different car, the 2013 GMC Acadia, 2013 Chevrolet Traverse, and 2013 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the air inlet grille. Refer to Air Inlet Grille Panel Replacement .
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the stabilizer link at the front strut. Refer to Stabilizer Shaft Link Replacement .
- Remove the wheel speed sensor wiring harness (1) and (2) from the front strut (3).
- If removing the front strut to service any other suspension or steering component, scribe a line in the steering knuckle against the front strut. This will aid in the realigning the front suspension.
- Lower the vehicle to gain access to the upper strut mounting bolts.
- Remove the front strut mounting bolts and nuts.
- Remove the upper strut mounting nuts.
- Separate the front strut from the steering knuckle.
- Remove the front strut assembly from the vehicle.
- If replacing the strut or the spring, refer to Strut, Strut Component or Spring Replacement .
NOTE:
To reduce the brake hose stress during strut removal, install a jack stand under the steering knuckle.