Power Steering Fluid Cooler Replacement

WARNING: This page is about a different car, the 2013 GMC Acadia, 2013 Chevrolet Traverse, and 2013 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Power Steering Fluid Cooler

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures For the Acadia, remove the front bumper fascia. Refer to Front Bumper Fascia Replacement (Acadia) , Front Bumper Fascia Replacement (Enclave) or Front Bumper Fascia Replacement (Traverse) . For the Enclave, remove the front air deflector. Refer to Front Air Deflector Replacement (Enclave) , Front Air Deflector Replacement (Acadia) or Front Air Deflector Replacement (Traverse) . For the Traverse, remove the right front wheelhouse front liner. Refer to Front Wheelhouse Front Liner Replacement (Acadia, Enclave, Traverse) . Place drain pans under the vehicle. Remove as much power steering fluid from the power steering fluid reservoir as possible.
1	Power Steering Reservoir Inlet Hose Clamp
2	Power Steering Cooler Hose Clamp
3	Power Steering Fluid Cooler Nuts (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 30 N.m (22 lb in)
4	Power Steering Fluid Cooler Procedure Fill and bleed the power steering system. Refer to Power Steering System Bleeding . Clean any excess power steering fluid from the vehicle.