FixVault
Home › Chevrolet › 2012 › Traverse LS, AWD › Repair and Diagnosis › External Pages › Different car › Section 167 (Rear Drive Axle) › Repair Instructions › Rear Differential Clutch Control Module Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2013 GMC Acadia, 2013 Chevrolet Traverse, and 2013 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the propeller shaft assembly. Refer to Propeller Shaft Replacement .
    3. Fig 1: Torque Tube Mounting Bolt
    GM1848880Courtesy of GENERAL MOTORS COMPANY
  3. Remove the torque tube mounting bolt.
    4. Fig 2: Torque Tube
    GM1848899Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    DO NOT allow the torque tube to hang, support with a suit stand.

  4. Lower the torque tube to gain access to the clutch control module.
    5. Fig 3: Clutch Control Module Electrical Connectors
    GM1848846Courtesy of GENERAL MOTORS COMPANY
  5. Disconnect the electrical connectors from the clutch control module.
    6. Fig 4: Clutch Control Module Screws
    GM1848855Courtesy of GENERAL MOTORS COMPANY
  6. Remove the screws for the clutch control module.
  7. Remove the clutch control module from the torque tube.
About FixVault