Initialization/Teach Procedure, Manual Method, New/First Time Installation

WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.

Perform the initialization/teach procedure at first operation test of the sunroof. Ensure the electrical harness on the headliner is connected and the engine running and the vehicle in park.

Press the sunroof switch to the close position until the window stalls at the close hard stop in the full close position, and then moves slightly to the soft stop position. Release the button. This is the initialization portion.
Verify the operation of the sunroof window and sunshade runs two or three times full cycles.

The initialization teach procedure in not completed if one of the following events occurs before the initialization/teach cycle is done:

The sunroof switch in not held in the close position.
Ignition and/or battery power has been removed.
The window panel has not reached the close position, and/or the sunshade has not reached the close position.

If the initialization/teach procedure is not carried out completely, the procedure has to be started again.