FixVault
Home › Chevrolet › 2012 › Traverse LS, AWD › Repair and Diagnosis › External Pages › Different car › Section 8 (Lighting System) › Diagnostic Information and Procedures › DTC B3883 › Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the X902 inline harness connector.
  2. Test for less than 10 Ω between the ground circuit terminal 15 and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Connect a test lamp between the control circuit terminal 1 and ground.
  4. Ignition ON, command the license plate lamps ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the selected states.
    • If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the K9 BCM.
    • If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K9 BCM.
  5. If all circuits test normal, test or replace the E7L license plate lamp-left or E7R license plate lamp-right.
About FixVault