Installation Procedure

WARNING: This page is about a different car, the 2011 Chevrolet Volt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Electronic Parking Brake Control Module

Courtesy of GENERAL MOTORS CORP.

Insert the electronic parking brake control module (1) hanger into the grommet in the vehicle body.
Raise the front of the electronic parking brake control module and install onto the studs in the vehicle body.

Fig 2: Electronic Parking Brake Control Module And Nuts

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the electronic parking brake control module nuts (1) and tighten to 10 N.m (89 lb in).
Connect the electronic parking brake control module electrical connector.

Fig 3: Parking Brake Cable And Nut

Courtesy of GENERAL MOTORS CORP.

Install the parking brake cable nut (1) to the electronic parking brake control module and tighten to 6 N.m (53 lb in).
Install the left rear wheelhouse panel liner. Refer to Rear Wheelhouse Panel Liner Replacement .
Install the left rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
Enable the parking brake cable adjuster. Refer to Parking Brake Cable Adjuster Enabling .