Component Testing
- Vehicle OFF, disconnect the X1 and X2 harness connectors at the transmission.
- Test for 15-25 Ω between the AC circuit at X2 terminal 1 and the AC circuit at X2 terminal 2.
- If not within the specified range, replace the drive motor generator 2 position sensor.
- Test for 35-55 Ω between the signal circuit at X1 terminal 3 and the signal circuit at X1 terminal 4.
- If not within the specified range, replace the drive motor generator 2 position sensor.
- Test for 35-55 Ω between the signal circuit at X1 terminal 1 and the signal circuit at X1, terminal 2.
- If not within the specified range, replace the drive motor generator 2 position sensor.
- Test for greater than 15 Ω between the terminals listed below and ground:
- X1 terminal 1
- X1 terminal 2
- X1 terminal 3
- X1 terminal 4
- X2 terminal 1
- X2 terminal 2
- If less that the specified value, replace the drive motor generator 2 position sensor.
- Test for infinite resistance between the terminals listed below:
- X1 terminal 1 and X1 terminal 3
- X1 terminal 1 and X2 terminal 1
- X1 terminal 3 and X2 terminal 1
- If less that the specified value, replace the drive motor generator 2 position sensor.