FixVault
Home › Chevrolet › 2013 › Cruze LT, Automatic Trans › Repair and Diagnosis › External Pages › Different car › Section 438 (Disc Brake System) › Repair Instructions › Rear Brake Shield Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2014 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Wheel Bearing/Hub, Rear Brake Shield And Steering Knuckle
    GM2027698Courtesy of GENERAL MOTORS COMPANY
  1. Position the rear brake shield (1) and wheel bearing/hub assembly (2) onto the rear axle assembly.
    2. Fig 2: Wheel Bearing/Hub Mounting Bolts
    GM2027695Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Install wheel bearing/hub mounting bolts (1) and tighten a first pass to 50 (37 lb ft).
  3. Tighten the wheel bearing/hub mounting bolts (1) a final pass to an additional 30 - 45 degrees, using the EN-45059  meter.
    4. Fig 3: Wheel Speed Sensor And Wheel Speed Sensor Mounting Bolt
    GM2027694Courtesy of GENERAL MOTORS COMPANY
  4. Install the wheel speed sensor (2).
  5. Install the wheel speed sensor bolt (1) and tighten to 6 (53 lb in).
  6. Install the brake rotor. Refer to Rear Brake Rotor Replacement .
  7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  8. Lower the vehicle.
About FixVault