FixVault
Home › Chevrolet › 2013 › Impala LS › Repair and Diagnosis › Brakes › Traction Control › Antilock Brake System › Diagnostic Information and Procedures › DTC C0292 › Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the yaw rate and lateral acceleration sensor connector.
  2. Ignition OFF, test for less than 1 Ω between the low reference circuit terminal 6 and ground.
    • If greater than 1 Ω, test the low reference circuit terminal 6 and the EBCM ground circuit terminal 25 for an open/high resistance. If the circuits test normal, replace the EBCM.
  3. Test the lateral accelerometer 12 V reference circuit terminal 1, for an open/high resistance or a short to voltage or ground.
    • If all circuits test normal, replace the yaw rate sensor/lateral acceleration sensor.
    • If the DTC sets again after replacing the yaw rate sensor/lateral acceleration sensor, replace the EBCM.
About FixVault