FixVault
Home › Chevrolet › 2013 › Spark LS, Standard Trans › Repair and Diagnosis › Brakes › Traction Control › Antilock Brake System › Repair Instructions › Rear Wheel Speed Sensor Replacement › Installation Procedure

Installation Procedure

    Fig 1: Retaining Clip
    GM2308709Courtesy of GENERAL MOTORS COMPANY
  1. Install the wheel speed sensor (3) to the knuckle.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the wheel speed sensor to knuckle retaining bolt (2) and tighten to 8.5 N.m (75 lb in).
  3. Install the wheel speed sensor harness to the retaining clip (1).
    4. Fig 2: Wheel Speed Sensor Harness And Rear Axle Mounted Bracket
    GM2308708Courtesy of GENERAL MOTORS COMPANY
  4. Attach the wheel speed sensor harness to the rear axle mounted bracket (1).
    5. Fig 3: Wheel Speed Sensor Electrical Connector
    GM2308707Courtesy of GENERAL MOTORS COMPANY
  5. Attach the wheel speed sensor harness to from the body frame mounted bracket (2).
  6. Connect the wheel speed sensor electrical connector (1).
  7. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  8. Lower the vehicle.
About FixVault