FixVault
Home › Chevrolet › 2013 › Traverse LS, FWD › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Controls/Fuel - 3.6L (LLT) - Repair Instructions › Repair Instructions › Camshaft Position Sensor Replacement - Bank 1 (Right Side) Intake › Installation Procedure

Installation Procedure

    Fig 1: CMP Sensor Bolt And Sensor
    GM1860459Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  1. Install the CMP sensor (2) and bolt. Tighten the bolt to 10 N.m (89 lb in).
    2. Fig 2: Intake And Exhaust Camshaft Position (CMP) Sensors
    GM1860428Courtesy of GENERAL MOTORS COMPANY
  2. Connect the engine wiring harness electrical connector (1) to the bank 1 intake CMP sensor (2).
About FixVault