FixVault
Home › Chevrolet › 2013 › Trax LS, Automatic Trans › Repair and Diagnosis › External Pages › Different car › Section 30 (Rear Drive Axle) › Repair Instructions › Rear Wheel Drive Module Differential Clutch Control Module Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2016 Chevrolet Trax and 2016 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Differential Clutch Control Module
    GM2771708Courtesy of GENERAL MOTORS COMPANY
  1. Position the differential clutch control module (2) on the differential carrier.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the mounting screws (1) to the differential carrier and tighten to 22 N.m (16 lb ft).
  3. Connect the electrical connector (3) to the differential carrier.
    4. Fig 2: Electrical Tie
    GM2771660Courtesy of GENERAL MOTORS COMPANY
  4. Secure the differential control module to the differential clutch using the electrical tie (1).
    5. Fig 3: Wiring Harness And Retainers
    GM2769927Courtesy of GENERAL MOTORS COMPANY
  5. Connect the electrical connector (3).
  6. Install the wiring harness retainers (2) and (1) to the differential clutch control module.
    7. Fig 4: Differential Clutch Control Module Shield
    GM2771626Courtesy of GENERAL MOTORS COMPANY
  7. Position the shield (2) on the differential clutch control module (1).
  8. Install the 2 mounting screws (4) and tighten to 11 N.m (97 lb in).
  9. Install the mounting nut (3) and tighten to 10 N.m (89 lb in).
  10. Install the propeller shaft to the rear differential.
  11. Remove the support and lower the vehicle.
  12. Reprogram the differential clutch control module. Refer to Rear Differential Clutch Control Module Programming and Setup .
About FixVault