Circuit/System Verification
- Vehicle ON.
- Verify DTC P0A45, P0A46, P0C57, P0C58, P0C61, P0C62, or P1B04 is not set.
- If any of the DTCs are set
Refer to DTC P0A45, P0A46, P0C57, P0C58, P0C61, P0C62, or P1B04 .
- If none of the DTCs are set
- If any of the DTCs are set
- Verify DTC P0C4F is not set.
- If the DTC sets
- Perform each of the operations listed below one at a time until the fault is corrected.
- Program the T6 Power Inverter Module
- Replace the B228B Drive Motor 2 Position Sensor
- Replace the M15B Drive Motor 2
- Replace the T6 Power Inverter Module
- Repeat the DTC check in step 3.
- If the DTC does not set
- All OK.