FixVault
Home › Chevrolet › 2014 › Camaro Z/28 › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Controls And Fuel - 6.2L, Or 7.0L - Repair Instructions › Repair Instructions › Throttle Body Assembly Replacement (Except LSA) › Installation Procedure

Installation Procedure

    Fig 1: Identifying Throttle Body To Intake Manifold Retaining Bolts
    GM1950738Courtesy of GENERAL MOTORS COMPANY
  1. Install a NEW throttle body to intake manifold gasket (2). Align the locating tab of the gasket with the notch in the manifold.
  2. Install the throttle body (1) to the intake manifold.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the throttle body to intake manifold retaining bolts (3) and tighten to 10 N.m (89 lb in).
  4. Install the electrical wire harness connector from the throttle body.
  5. Install the outlet duct. Refer to Air Cleaner Resonator and Outlet Duct Replacement .
  6. Perform the throttle learn procedure. Refer to Throttle/Idle Learn .
About FixVault