FixVault
Home › Chevrolet › 2014 › Express 1500 LS, RWD › Repair and Diagnosis (Single Page) › Accessories & Equipment › Communication Devices › Programming And Setup - All Systems › Repair Instructions › Chassis Control Module Programming and Setup › Chassis Control Module Programming

Chassis Control Module Programming

To program and setup an existing or new replacement Chassis Control Module, perform the following procedure:

  1. Access the Service Programming System (SPS) and follow the on-screen instructions. Refer to Service Programming System (SPS) .
  2. On the SPS Supported Controllers screen, select K38 Chassis Control Module - Programming and follow the on-screen instructions.

If the Chassis Control Module fails to accept the program, verify all scan tool and Chassis Control Module connections are secure.

NOTE:

After programming is completed, perform the following to avoid future misdiagnosis:

  1. Turn the ignition OFF for 10 seconds.
  2. Open and close the door.
  3. Connect the scan tool to the data link connector.
  4. Ignition ON, engine OFF.
  5. Clear all DTC's from all modules.
About FixVault