Steering Linkage Inner Tie Rod Replacement

Preliminary Procedures

1. Remove the steering gear boot. Refer to Steering Gear Boot Replacement .
2. After removing the steering gear boot, inspect the steering linkage inner tie rod for evidence of corrosion or contamination. If none is evident, continue with the repair. If corrosion or contamination is evident, replace the steering gear. Refer to Electric Belt Drive Rack and Pinion Steering Gear Replacement .

Procedure

1. To change the driver's side steering linkage inner tie rod, turn the steering wheel to expose the first two inches of steering gear rack. Hold the rack with a wrench across the two recesses in the rack sides. Care must be taken to avoid any marks or damage on the teeth or on the back of the rack.
2. Use the J-34028  wrench to remove and install the steering linkage inner tie rod.
3. Measure and adjust the front toe. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment .