FixVault
Home › Chevrolet › 2014 › Spark EV › Repair and Diagnosis › Brakes › Traction Control › Antilock Brake System › Repair Instructions › Front Wheel Speed Sensor Replacement › Removal Procedure

Removal Procedure

WARNING:

Refer to Brake Dust Warning .

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Remove the front compartment front splash shield. Refer to Front Compartment Splash Shield Replacement (Front) , Front Compartment Splash Shield Replacement (Middle) , Front Compartment Splash Shield Replacement (Rear) .
    4. Fig 1: Wheel Speed Sensor Electrical Connector
    GM3227623Courtesy of GENERAL MOTORS COMPANY
  4. Disconnect the wheel speed sensor electrical connector (1) and release the connector from the front compartment side rail.
    5. Fig 2: Wheel Speed Sensor Harness Clips
    GM3223073Courtesy of GENERAL MOTORS COMPANY
  5. Release the wheel speed sensor harness clips (1) from the left front brake pipe.
    6. Fig 3: Front Wheel Speed Sensor Harness Grommet
    GM3227624Courtesy of GENERAL MOTORS COMPANY
  6. Release the front wheel speed sensor harness grommet (1) from the strut bracket.
    7. Fig 4: Wheel Speed Sensor Bolt
    GM3227626Courtesy of GENERAL MOTORS COMPANY
  7. Clean the wheel speed sensor mounting area on the steering knuckle of any accumulated dirt and debris.
  8. Remove the wheel speed sensor bolt (1).
  9. Remove the wheel speed sensor from the steering knuckle.
About FixVault