FixVault
Home › Chevrolet › 2014 › Traverse LS, 4D Utility › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Controls And Fuel - 3.6L (LLT) - Repair Instructions › Repair Instructions › Camshaft Position Sensor Replacement - Bank 2 (Left Side) Intake › Installation Procedure

Installation Procedure

  1. Install the CMP sensor (3) and bolt.
    Fig 1: View Of CMP Sensor Bolt & Sensor
    GM1860459Courtesy of GENERAL MOTORS COMPANY
    CAUTION: Refer to Fastener Caution .

    Tighten 

    Tighten the bolt to 10 N.m (89 lb in).

  2. Connect the engine wiring harness electrical connector (8) to the bank 2 intake CMP sensor (7).
    Fig 2: Identifying Intake & Exhaust Camshaft Position (CMP) Sensors
    GM1860429Courtesy of GENERAL MOTORS COMPANY
  3. Position and install the power steering fluid reservoir bracket (2).
    Fig 3: Identifying Remote Power Steering Fluid Reservoir, Bracket & Bolts
    GM1856014Courtesy of GENERAL MOTORS COMPANY
  4. Install the power steering fluid reservoir bracket bolts (1).

    Tighten 

    Tighten the bolts to 9 N.m (8 lb in).

  5. Install the radiator inlet hose to the water outlet. Refer to Radiator Inlet Hose Replacement .
  6. Install the engine mount strut bracket. Refer to Engine Mount Strut Bracket Replacement - Right Side .
About FixVault