FixVault
Home › Chevrolet › 2014 › Traverse LS, 4D Utility › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Controls And Fuel - 3.6L (LLT) - Repair Instructions › Repair Instructions › Ignition Coil Replacement - Bank 1 › Installation Procedure

Installation Procedure

  1. Install the ignition coil(s).
    Fig 1: Ignition Coil View
    GM860797Courtesy of GENERAL MOTORS COMPANY
  2. Install the ignition coil bolt(s).
    CAUTION: Refer to Fastener Caution .

    Tighten 

    Tighten the bolt(s) to 10 N.m (89 lb in).

  3. Connect the engine wiring harness electrical connector(s) (1) to the ignition coil(s) (4).
    Fig 2: View Of Ignition Coil Electrical Connector
    GM1860397Courtesy of GENERAL MOTORS COMPANY
  4. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
About FixVault