FixVault
Home › Chevrolet › 2014 › Traverse LS, 4D Utility › Repair and Diagnosis › External Pages › Different car › Section 102 (Object Detection And Pedestrian Protection System) › Diagnostic Information and Procedures › DTC B0010: Reverse Gear Signal › Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2015 GMC Acadia, 2015 Chevrolet Traverse, and 2015 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the rearview camera.
  2. Engine running, park brake applied, transmission in REVERSE, test for B+ between the B+ circuit terminal 3 and ground.
    • If less than the specified value, test the control circuit for a short to ground or an open/high resistance.
  3. If all circuits test normal, replace the BCM.
About FixVault