Installation Procedure

Fig 1: Starter Mounting Stud And Bolt

Courtesy of GENERAL MOTORS COMPANY

CAUTION:

Install the starter (3) into position and tighten the starter mounting bolt (2) and the starter mounting stud (1) to 25 (18 lb ft).

Fig 2: Starter Solenoid

Courtesy of GENERAL MOTORS COMPANY

Install the battery positive and negative cable (3), to the starter.
Install the battery positive cable terminal to the starter and tighten the nut (1) to 9 (80 lb in).
Install the battery negative cable and tighten the starter nut (2) to 17 (13 lb ft).

Fig 3: Intake Manifold Support

Courtesy of GENERAL MOTORS COMPANY

Install the intake manifold support (3) and the 2 intake manifold support bolts (1, 2) and tighten to 8 (71 lb in).
If equipped with AWD, install the generator. Refer to Generator Replacement (2H0) .
If equipped , install the front compartment front center insulator. Refer to Front Compartment Front Center Insulator Replacement .
If equipped, install the drive train and front suspension frame transmission protector. Refer to Drivetrain and Front Suspension Frame Transmission Protector Replacement .
Lower the vehicle.
Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .