FixVault
Home › Chevrolet › 2014 › Trax LS, Automatic Trans › Repair and Diagnosis › Electrical › Charging Systems › Battery, Charging System And Starting System › Repair Instructions › Starter Replacement (LUV) › Installation Procedure

Installation Procedure

    Fig 1: Starter And Components
    GM2191725Courtesy of GENERAL MOTORS COMPANY
  1. Install the starter (3).
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the washer (5) and the starter mounting fastener stud (4). Tighten to 25 N.m (18 lb ft).
  3. Install the upper starter mounting fastener (2) and the washer (1). Tighten to 25 N.m (18 lb ft).
    4. Fig 2: Generator Positive Cable, Starter Positive Cable And Ground Cable
    GM2191724Courtesy of GENERAL MOTORS COMPANY
  4. Install the battery negative ground cable (6) and tighten the fastener (5) to 17 N.m (13 lb ft).
  5. Install the engine harness cable (4) to starter solenoid and tighten the fastener (3) to 5.5 N.m (49 lb in).
  6. Install the battery positive cable (1) and tighten the fastener (2) to 13 N.m (115 lb in).
    7. Fig 3: Heated Oxygen Sensor Bracket
    GM2777069Courtesy of GENERAL MOTORS COMPANY
  7. Install the heated oxygen sensor bracket (2) and tighten the fastener (1) to 22 N.m (16 lb ft).
  8. If equipped with AWD, install the transfer case. Refer to Transfer Case Replacement .
  9. Install the drivetrain and front suspension frame transmission protector. Refer to Drivetrain and Front Suspension Frame Transmission Protector Replacement .
  10. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
About FixVault