Installation Procedure
WARNING: This page is about a different car, the 2013 Chevrolet Trax and 2013 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- Install the brake pedal position sensor (1).
- Install the brake pedal position sensor bolt (1) and tighten to 3 (27 lb in).
- Install the left side front floor air outlet duct. Refer to Floor Front Air Outlet Duct Replacement - Left Side .
- Connect the brake pedal position sensor electrical connector.
- Calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration
NOTE:
Ensure the fork of the brake pedal position sensor is positioned over the brake pedal post.
CAUTION:
Refer to Fastener Caution .