FixVault
Home › Chevrolet › 2014 › Volt › Repair and Diagnosis › Brakes › Parking Brake System › Diagnostic Information and Procedures › DTC C0558: Calibration Data Error › Circuit/System Verification

Circuit/System Verification

  1. Vehicle in service mode.
  2. Verify that DTC C0558 55 is not set.
    • If DTC C0558 55 is set 
    1. Program the K83 parking brake control module. Refer to Electronic Parking Brake Control Module Programming and Setup .
    2. Vehicle in service mode. Apply and release the park brake.
    3. Verify the DTC is not set.
      • If the DTC is set,

        replace the K83 parking brake control module.

      • If the DTC is not set
    4. All OK.
    • If DTC C0558 55 is not set 
  3. Verify the scan tool Park Brake Cable Position parameter is less than 1251 counts.
    • If 1251 counts or greater 
    1. Verify the park brake cable is connected properly. Refer to Park Brake System Diagnosis 
    2. Check park brake pads for excessive wear. Refer to Disc Brake System Diagnosis
    • If less than 1251 counts 
  4. All OK.
About FixVault