FixVault
Home › Chevrolet › 2014 › Volt › Repair and Diagnosis › Hybrid/Electric Powertrain › Cooling Systems › Hybrid/EV Cooling System › Repair Instructions › Drive Motor Generator Control Module Coolant Pump Hose Replacement › Installation Procedure

Installation Procedure

  1. Install the drive motor generator control module coolant pump hose to the vehicle.
    Fig 1: Motor Generator Control Module Coolant Pump Hose And Clamp
    GM2392402Courtesy of GENERAL MOTORS COMPANY
  2. Install the drive motor generator control module coolant pump hose (2) to the drive motor battery coolant air separator.
  3. Install the drive motor generator control module coolant pump hose clamp (1) at drive motor battery coolant air separator using BO-38185  pliers.
  4. Install the drive motor generator control module coolant pump hose (2) to the generator control module coolant pump.
    Fig 2: Drive Motor Generator Control Module Coolant Pump Hose Clamp
    GM2392403Courtesy of GENERAL MOTORS COMPANY
  5. Install the drive motor generator control module coolant pump hose clamp (1) at generator control module coolant pump using BO-38185  pliers.
  6. Install the front wheelhouse front liner on the driver and passenger side. Refer to Front Wheelhouse Front Liner Replacement .
  7. Remove the drain pan.
  8. Fill the cooling system.
About FixVault