FixVault
Home › Chevrolet › 2015 › Cruze LS, 1.8L Eng VIN H, Standard Trans › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Controls And Fuel - 1.8L (LUW, LWE) - Repair Instructions › Repair Instructions › Knock Sensor Replacement › Installation Procedure

Installation Procedure

  1. Install the knock sensor (2) to the bracket (3).
    Fig 1: Knock Sensor And Bracket
    GM2189291Courtesy of GENERAL MOTORS COMPANY
  2. Install the sensor bolt (1) and tighten to 20 N.m (15 lb ft).
    CAUTION: Refer to Fastener Caution
  3. Connect the wiring harness plug.
  4. Install the intake manifold bracket (1).
    Fig 2: Intake Manifold Bracket
    GM2026538Courtesy of GENERAL MOTORS COMPANY
  5. Clip in the wiring harness.
  6. Install the 2 intake manifold bracket bolts (2, 3) and tighten to 8 N.m (71 lb in).
  7. Connect the negative cable to the battery. Refer to Battery Negative Cable Disconnection and Connection .
  8. Close the hood.
About FixVault