FixVault
Home › Chevrolet › 2015 › Tahoe SSV › Repair and Diagnosis › Brakes › Traction Control › Antilock Brake System › Repair Instructions › Front Wheel Speed Sensor Replacement (With 9C1) › Installation Procedure

Installation Procedure

    Fig 1: Wheel Speed Sensor
    GM4205975Courtesy of GENERAL MOTORS COMPANY
  1. Install Wheel Speed Sensor (1).
    2. Fig 2: Wheel Speed Sensor Bolt
    GM4205949Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Fastener Caution

  2. Install Wheel Speed Sensor Bolt (1) and tighten 13 (115 lb in)
  3. Install the front wheel hub and bearing assembly to the steering knuckle while carefully feeding the wheel speed sensor harness through the brake shield.
  4. Install the front wheel hub and bearing bolts.Front Wheel Hub, Bearing, and Seal Replacement
    5. Fig 3: Wheel Speed Sensor Harness Clip
    GM4205944Courtesy of GENERAL MOTORS COMPANY
  5. Secure Wheel Speed Sensor Harness Clip (1) @Steering Knuckle
    6. Fig 4: Wheel Speed Sensor Harness Clip
    GM4205938Courtesy of GENERAL MOTORS COMPANY
  6. Secure Wheel Speed Sensor Harness Clip (1) @Brake Hose
    7. Fig 5: Wheel Speed Sensor Electrical Connector Clip
    GM4205936Courtesy of GENERAL MOTORS COMPANY
  7. Secure Wheel Speed Sensor Electrical Connector Clip (1)
  8. Connect Wheel Speed Sensor Electrical Connector
  9. Install Front Brake Rotor. Front Brake Rotor Replacement
  10. Remove the tire and wheel assembly. Tire and Wheel Removal and Installation (6-Lug Wheel)
  11. Perform the Diagnostic Repair Verification after completing the repair:Diagnostic Repair Verification
About FixVault