Installation Procedure
- Position the electronic parking brake control module (1) to the electronic parking brake control module bracket.
- Inspect the O-ring seals on the spindle and the intermediate cable for damage and correct positioning and replace, if necessary.
- Install the parking brake intermediate cable nut (1) and tighten to 6 N.m (53 lb in).
- Maneuver and install the electronic parking brake control module and bracket to the rear suspension support.
- Connect the electronic parking brake control module electrical connector.
- Install the electronic parking brake control module bracket bolts (1) and tighten to 9 N.m (80 lb in).
- Install the electronic parking brake control module bolts (1) and tighten to 7 N.m (62 lb in).
- Install Exhaust Muffler - Exhaust Muffler Replacement (LGX, Coupe)Exhaust Muffler Replacement (LGX, Convertible)Exhaust Muffler Replacement (LT1, Coupe)Exhaust Muffler Replacement (LT1, Convertible)Exhaust Muffler Replacement (LTG, Coupe)Exhaust Muffler Replacement (LTG, Convertible)
- Program the electronic parking brake control module. Electronic Parking Brake Control Module Programming and Setup
CAUTION:
Refer to Fastener Caution .
NOTE:
When installing the electronic park brake intermediate cable nut to the electronic park brake module spindle, hold the spindle housing securely to avoid distorting the housing.