FixVault
Home › Chevrolet › 2016 › Malibu LS › Repair and Diagnosis › External Pages › Different car › Section 33 (Anti-Lock Brake System) › Diagnostic Information and Procedures › DTC C0252: Vehicle Stability Control Module Sensor › Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2015 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON.
  2. Verify that DTC C0187, C0196, C0287 or C0710 is not set.
    • If none of the DTCs are set 
  3. Perform the Vehicle Yaw Sensor Learn  and Steering Angle Sensor Centering .
  4. Ignition ON.
  5. Verify DTC C0252 does not set while operating the vehicle within the Conditions for Running the DTC.
    • If the DTC is set 
    1. Replace the B99 Steering Wheel Angle Sensor.
    2. Ignition ON
    3. Verify DTC C0252 does not set while operating the vehicle within the Conditions for Running the DTC.
      • If the DTC is set
    4. Replace the K36 Inflatable Restraint Sensing and Diagnostic Module
    5. Ignition ON.
    6. Verify the DTC does not set while operating the vehicle within the Conditions for Running the DTC.
      • If the DTC sets, replace the K17 Electronic Brake Control Module.
    • If the DTC is not set 
  6. All OK.
About FixVault