FixVault
Home › Chevrolet › 2016 › Malibu LS › Repair and Diagnosis › External Pages › Different variant/trim › Section 15 (Hybrid/EV Control System) › Diagnostic Information and Procedures › DTC P3260: Internal Control Module Drive Motor Control Performance › Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Verify DTCs that inhibit Autostop operation, or stuck clutch DTCs P07A3 or P07A5, or pressure controls solenoid DTCs P0960, P0962, or P0963 are not set.
    • If none of the DTCs are set 
  2. Verify DTC P3260 is not set.
    • If the DTC is set 
    1. Program the T6 Power Inverter Module.
      2. NOTE:

      The transmission must be in Neutral for greater than 33 seconds.

    2. Vehicle ON, verify the DTC does not set.
      • If the DTC sets, replace the T6 Power Inverter Module.
      • If the DTC is not set
    3. All OK.
    • If the DTC is not set 
  3. All OK.
About FixVault