FixVault
Home › Chevrolet › 2016 › Spark LS, Standard Trans › Repair and Diagnosis › Electrical › Charging Systems › Battery, Charging System And Starting System › Repair Instructions › Battery Positive Cable Replacement › Installation Procedure

Installation Procedure

    Fig 1: Battery Positive Cable Nut, Bolt And Protective Cover
    GM4009340Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  1. Install the battery positive cable (5) to the generator B (+) stud and tighten the generator B (+) nut (2) to 14 N.m (10 lb ft).
  2. Install the protective cover (3).
  3. Install the battery positive cable nut (1) and tighten to 14 N.m (10 lb ft).
  4. Install the battery positive cable ground bolt (4) and tighten to 22 N.m (16 lb ft).
    5. Fig 2: Battery Negative And Positive Ground Nut
    GM4009339Courtesy of GENERAL MOTORS COMPANY
  5. Install the battery positive cable (2) to the frame stud ground and tighten the battery negative and positive ground nut (1) to 22 N.m (16 lb ft).
  6. Install the battery. Battery Replacement .
    7. Fig 3: Battery Positive Cable Retainers And Battery Positive Cable
    GM4009338Courtesy of GENERAL MOTORS COMPANY
  7. Install the battery positive cable retainers (1) and the battery positive cable to the battery tray.
    8. Fig 4: Battery Positive Cable Junction Block Post Nut
    GM4087640Courtesy of GENERAL MOTORS COMPANY
  8. Install the battery positive cable (3) to the battery and the engine wiring harness junction block.
  9. Install the battery positive cable junction block post nut (1) and tighten to 6 N.m (53 lb in).
  10. Install the engine wiring harness junction block nut (2) and tighten to 22 N.m (16 lb ft).
    11. Fig 5: Body Wiring Harness Connectors
    GM4087647Courtesy of GENERAL MOTORS COMPANY
  11. Install the body wiring harness (2) to the battery positive cable junction block and connect the body wiring harness connectors (1).
    12. Fig 6: Battery Positive Cable Terminal Cover
    GM4087645Courtesy of GENERAL MOTORS COMPANY
  12. Install the battery positive cable terminal cover (2).
  13. Install the engine wiring harness junction block cover (1).
  14. Install the engine control module (S53) to the battery tray. Engine Control Module Replacement
  15. Connect the battery negative cable. Battery Negative Cable Disconnection and Connection .
About FixVault