Installation Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.

Install a new clamp (2) loosely on the inner part of the steering gear boot.

Fig 1: Steering Gear Boot
Courtesy of GENERAL MOTORS COMPANY
Apply grease from the service kit to the indicated locations.
Install the steering gear boot (1) over the steering linkage inner tie rod and onto the steering gear.
NOTE: The steering gear boot must seat in the appropriate groove on the steering gear.
Using CH-804 pliers crimp the inner steering gear boot clamp (1).

Fig 2: Steering Gear Inner Boot Clamp
Courtesy of GENERAL MOTORS COMPANY
Install the steering gear outer boot clamp (2).

Fig 3: Steering Linkage Inner Tie Rod Nut
Courtesy of GENERAL MOTORS COMPANY
Install the steering linkage inner tie rod nut (1).
Install the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement .