FixVault
Home › Chevrolet › 2016 › Traverse LS, AWD › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Controls And Fuel - 3.6L (LLT) - Repair Instructions › Repair Instructions › Knock Sensor Replacement - Bank 2 › Removal Procedure

Removal Procedure

    Fig 1: Identifying Engine Wiring Harness Electrical Connector
    GM1860484Courtesy of GENERAL MOTORS COMPANY
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the engine oil filter. Refer to Engine Oil and Oil Filter Replacement .
  3. Remove Catalytic Converter - Left Side Catalytic Converter Replacement - Left Side
  4. Lower the vehicle.
  5. Disconnect the engine wiring harness electrical connector (2) from the bank 2 knock sensor (3).
    6. Fig 2: View Of Left Knock Sensor
    GM860802Courtesy of GENERAL MOTORS COMPANY
  6. Loosen the knock sensor bolt and remove the knock sensor.
About FixVault