HVAC Operation During Remote Start (PIT5061C)
Publication date: 2017-05-01Reference number: PIT5061C
HVAC OPERATION DURING REMOTE START
TECHNICAL SERVICE BULLETIN
SERVICE INFORMATION
| Brand: | Model: | Model Year: | VIN: | Engine: | Transmission: | ||
|---|---|---|---|---|---|---|---|
| from | to | from | to | ||||
| Buick | Enclave | 2008-2017 | All | All | All | All | |
| Chevrolet | Traverse | 2009-2017 | All | All | All | All | |
| GMC | Acadia | 2007-2016 | All | All | All | All | |
| GMC | Acadia Limited | 2017 | All | All | All | All | |
| Saturn | Outlook | 2000-2011 | All | All | All | All | |
Supersession Statement
This PI was superseded to update Model Years. Please discard PIT5061B.
The following diagnosis might be helpful if the vehicle exhibits the symptom(s) described in this PI.
CONDITION/CONCERN
Operation of the HVAC controls during a remote start event.
RECOMMENDATION/INSTRUCTIONS
During remote start, automatic HVAC equipped vehicles will adjust cabin temperature and turn on defoggers according to outside temperature and default back to the previous key off setting when the key is inserted and rotated forward.
Refer to the table below for system operation.
| RPO CJ2 | |||
|---|---|---|---|
| OAT | High | Mid | Low |
| (above 86°F) | (50°F - 86°F) | (below 50°F) | |
| (above 30°C) | (10°C - 30°C) | (below 10°C) | |
| Front Blower | auto | auto | auto |
| Front Mode | panel | panel | defrost |
| Front Temp | full cold | 73tset | full hot |
| Compressor | on | on | on (above 2°C) |
| Recirc | auto recirc | auto recirc | auto recirc |
| Rear Blower | same as front | same as front | same as front |
| Rear Mode | same as front | same as front | same as front |
| Rear Temp | same as front | same as front | same as front |
| Rear Defog | off | off | on |
| Heated Seats | off | off | on |
On C67 systems, the system will operate the same settings as when the vehicle was last turned off.
All displays, LEDs, & backlighting are off during remote start.
Please follow this diagnostic or repair process thoroughly and complete each step. If the condition exhibited is resolved without completing every step, the remaining steps do not need to be performed.