FixVault
Home › Chevrolet › 2016 › Volt Premier › Repair and Diagnosis › Engine Performance › Ignition System › Engine Controls And Fuel - 1.5L (L3A) - Repair Instructions › Repair Instructions › Fuel Pressure Sensor Replacement › Installation Procedure

Installation Procedure

    Fig 1: Fuel Pressure Sensor, Seal Ring And Electrical Connector
    GM4091047Courtesy of GENERAL MOTORS COMPANY
  1. Install a NEW seal (3).
    2. CAUTION:

    Refer to Component Fastener Tightening Caution

  2. Install and tighten Fuel Pressure Sensor (2) to 15 N.m (11 lb ft)
  3. Connect the electrical connector (1).
  4. Remove the drain pan.
  5. Install Underbody Front Air Deflector - Left Side. Refer to Underbody Front Air Deflector Replacement - Left Side
  6. Cycle the ignition to run the fuel pump and check for fuel leaks.
About FixVault