FixVault
Home › Chevrolet › 2016 › Volt Premier › Repair and Diagnosis › Hybrid/Electric Powertrain › Cooling Systems › Hybrid/EV System Heating And Cooling › Repair Instructions › Drive Motor Control Module Radiator Inlet Hose Replacement › Installation Procedure

Installation Procedure

  1. Install the drive motor control module radiator inlet hose to the vehicle.
    2. Fig 1: Clamp And Coolant Hose
    GM4224581Courtesy of GENERAL MOTORS COMPANY
  2. Install Coolant Hose (1)
  3. Engage Clamp (2) Hose Clamp Replacement Guidelines - Spring Type
    4. Fig 2: Generator Control Module Coolant Pump Bracket And Nuts
    GM4091137Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Check the pump and the bracket for the correct original position.

  4. Install the generator control module coolant pump bracket (1).
    5. CAUTION:

    Fastener Caution

  5. Install the 2 generator control module coolant pump bracket nuts (2) and tighten to 9 N.m (80 lb in).
    6. Fig 3: Coolant Hose And Clip
    GM4091149Courtesy of GENERAL MOTORS COMPANY
  6. Install Clip (1)
  7. Install Coolant Hose (2)
    8. Fig 4: Clamp And Coolant Hose
    GM4091148Courtesy of GENERAL MOTORS COMPANY
  8. Install Coolant Hose (2)
  9. Engage Clamp (1)Hose Clamp Replacement Guidelines - Spring Type
  10. Install Headlamp Headlamp Replacement
  11. Install Front Wheelhouse Liner Front Wheelhouse Liner Replacement (Left Side)Front Wheelhouse Liner Replacement (Right Side)
  12. Lower the vehicle.
  13. Fill the cooling system. Drive Motor Generator Power Inverter Module Cooling System Draining and Filling 
About FixVault